When we use the warping machine, on the one hand, we should do a good job of the warping machine, on the other hand, we should do a good job of the warping machine, and on the other hand, we should do a good job of the warping machine. From mechanical transmission and control in the past to modern mechanical transmission and microcomputer control, technological design has also undergone qualitative changes. The moving speed of the fixed reed of the original slitting warping machine varies in stages. Therefore, in order to obtain a good warping forming, the requirements are generally met by adjusting the appropriate inclination angle of the inclined angle plate. However, the new high-speed meridian splitting machine can fix the tilt angle of the tilt angle plate, and the fixed moving speed can be changed without level, and the fixed moving speed is controlled by the microcomputer servo motor, which is very convenient to set and change, so as long as the appropriate fixed moving speed is calculated, the requirements can be met.
The new high-speed warping machine is widely used in the warping of twisted chemical fiber filament fabrics. It is an ideal slitting warping equipment matched with shuttleless looms. According to the design and calculation of the overall length and tension, it is pointed out that the new type of high-speed switching machine has a fixed inclination angle of the inclined angle plate and a constant moving speed of the reed. As long as the moving speed of the fixed amplitude box is appropriate, it can meet the requirements.
Warping machine manufacturer
1、 Check whether the relevant parts of the warping machine leak oil.
2、 Check the lubricating oil level.
3、 Check the main motor according to the main motor manual.
4、 Manually turn the gear and adjust the traverse gear clearance.
5、 Check the physical and chemical properties of the lubricating oil. If it does not meet the requirements, replace it.
6、 Check whether the air pressure pipe leaks or breaks.
7、 Check whether the brake band is worn.
8、 Check whether the synchronous belt is worn.
9、 Clean the flying hair or dust of the frequency converter.
10、 Check whether each induction probe is damaged or covered with dust.
The above is the detailed introduction of warping machine manufacturer